Full Product Manual

ManualsBrandsGHOST CONTROLS ManualsDoors & WindowsWater-Resistant Remote Transmitter with Universal Mounting Bracket for Gate Opener Systems

www.GhostControls.com

Made in China

AXR1C, Rev. 10-2018

GENERATING A NEW TRANSMITTING KEY CODE

CAUTION

Please READ and PROCEED with CAUTION

Each GHOST CONTROLS

remote transmitter has a unique key code sequence. Once a new key sequence is generated, the previous key code is lost. The new key code

will need to be programmed or “learned” into the gate opener to control the gate. See Programming Remote to Gate Controller on front page.

STEP

LED/ALARM

BEFORE PRESSING

BUTTONS SEQUENCE

TO PRESS

LED/ALARM

AFTER PRESSING

DESCRIPTION

Press & hold

AND

simultaneously for 10 seconds

on Remote until the LED goes

LED on Remote goes

Tells the remote transmitter that you are going to generate a new code. Step 2 & 3 must be completed

within 5 seconds while the LED is lit.

Release

AND

Remote LED is

Press & release or

on Remote

LED goes The remote button pressed in this step is now generating a new code.

ASSEMBLING THE UNIVERSAL CLAMP TO ATTACH TO YOUR REMOTE: (can be used on golf carts, tractors, motorcycle handlebars, and

even mounted outside on a post)

WARNING: This product can expose you to

chemicals including lead, which is known to the

State of California to cause cancer. For more

information, go to www.P65Warnings.ca.gov

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

■ This device may not cause harmful interference

■ This device must accept any interference received, including interference that may cause undesired operation.

WARNING G

Changes or modiﬁcations to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable pro-

tection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

■ Reorient or relocate the receiving antenna

■ Increase the separation between the equipment and receiver.

■ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

■ Consult the dealer or an experienced technician for help.

Optional Insert

Replace Screw

from one used with

visor clip