Installation Instructions

SETTING UP YOUR WIRELESS VEHICLE CONTROL UNIT BOARD:
BEFORE CONTINUING MAKE SURE YOUR GATE IS CLOSED. TURN THE GATE OFF BY TURNING THE
SWITCH TO THE OFF POSITION ON THE BOTTOM OF THE CONTROL BOX.
*The following steps can be performed indoors BEFORE digging and burying the Sensor Probe.
a. Remove the cover on Control Unit by sliding it upward to access the Control Unit board and install the two (2) batteries.
Shown below in Example A.
b. Insert/Install the batteries. Shown below in Example B.
TEACHING THE TRANSMITTER TO THE WIRELESS VEHICLE CONTROL
UNIT BOARD:
BEFORE CONTINUING MAKE SURE YOUR TRANSMITTER IS ALREADY CAPABLE OF OPENING THE GATE.
a. On Control Unit Board, press and hold the button below the “LEARN” LED light until the RED “LEARN” LED light is
on.
(shown below, Example A)
b. Release the button, the RED “LEARN” LED should remain ON indicating it is in “LEARNING” mode and waiting for
the signal from the transmitter.
(shown below, Example A)
NOTE
It will automatically exit “LEARNING MODE” after 60 seconds if no valid signal is detected.
c. Place the transmitter next to Control Unit Board. (shown below, Example B)
d. On the transmitter press and hold down the button that controls the gate. (shown below, Example B)
e. The RED “LEARN” LED on the Control Unit Board should go OFF indicating the signal is “LEARNED” and now can
open your gate.
(shown below, Example C)
Example A. Slide cover up. Example B. Add (2) C Batteries. Example B. All LED’s will turn ON
for 1 second when the unit powers
up and then will go OFF.
Example A. Press button until
RED LED light comes on
Example B. Place transmitter next
to Control Unit Board. Press and
hold the button that controls gate
Example C. RED LED light on control
board should go OFF. Now you can
OPEN your gate with vehicle sensor