Installation instructions

72  Configuring Content Checking GFI MailSecurity for Exchange/SMTP
Screenshot 61 - Content Checking: General Tab
5. If you want PGP encrypted emails to infringe this rule, select the
Block PGP encrypted emails check box.
6. Next, you need to configure whether to scan email bodies and
attachments, and the keywords an email must contain to trigger this
Content Checking rule. Click the Body tab to configure these options.
7. To configure this rule to check email bodies you need to select the
Block emails if content is found matching these conditions
(message body/attachments) check box.
8. You then need to specify the conditions that will infringe this rule
while scanning the bodies and attachments content. To enter a new
condition, type the keywords in the Edit condition box. Click the
required logical operator button to insert that operator at the current
cursor location in the Edit condition box. When the condition is
complete, click Add Condition to add the new condition to the rule.
The new condition is then displayed in the Current conditions list.
For example to enter the following condition, “confidential information
AND top secret”, you would perform the following steps:
In the Edit condition box, type “confidential information”.
Click AND to the right of the box.
Type “top secret” and click Add Condition.
NOTE: To remove a condition select it from the Current conditions
list and click Remove. To modify an existing condition, select it from
the Current conditions list to display it in the Edit condition box.
Modify the condition as required and then click Update to save your
changes.