Installation instructions

GFI MailSecurity for Exchange/SMTP Installing GFI MailSecurity  13
Screenshot 3 - SMTP Domain Wizard - Selecting domain type
b) Select Remote and then click Next.
c) Type the domain name in the Name box and then click Finish.
IMPORTANT NOTE ABOUT LOCAL DOMAINS
NOTE: Upon installation, GFI MailSecurity will import Local Domains
from the IIS SMTP service. If you add additional Local Domains in IIS
SMTP service, you must also add these domains to GFI MailSecurity
because this does not detect newly added Local Domains
automatically. You can add more/new Local Domains using the GFI
MailSecurity configuration. For more information, refer to the „Adding
local domains‟ section in the General Settings chapter of this manual.
Configure the domain to relay email to your mail server:
1. Right-click the domain you just created and then click Properties.
Select the Allow the Incoming Mail to be relayed to this domain
check box.
2. In the Route domain dialog box, click Forward all email to smart
host and type the IP address (in square brackets) of the server which
will handle the emails addressed to this new domain. For example,
[123.123.123.123]
NOTE: The square brackets are used to differentiate an IP address
from a hostname (which does not require square brackets), i.e., the
server detects an IP address from the square brackets.
3. Click OK.