Product manual

GFI LanGuard 2 Installing GFI LanGuard | 21
In a network, computers can be grouped and each group can be assigned to a relay agent as shown
below.
Figure 3: Relay Agent Mode
Note
For more information, refer to Configuring Relay Agents (page 53).
2.1.3 Deploying GFI LanGuard in Agent-less mode
Agent-less auditing is started from the GFI LanGuard management console. GFI LanGuard creates a
remote session with the specified scan targets and audits them over the network. On completion, the
results are imported into the results database and the remote session ends.
You can audit single computers, a range of specific computers and an entire domain/workgroup.