GFB DV+ Installation Instructions Part #T9352 GFB P.O. Box 1017 Riverwood, NSW 2210, Australia Ph: +612 9534 0099 Fax: +612 9534 3999 Website: www.gfb.com.au Email: sales@gfb.com.
Installation Instructions for GFB DV+ TMS valve (part # T9352) Locate factory diverter valve. It will be mounted directly on the turbo compressor cover, either above or below the plastic intake pipe as shown below: Remove the intake duct to gain access to the diverter valve and the 3 bolts holding it to the turbo.
The DV+ difference Whilst the DV+ might look pretty basic, there is a very significant difference in the way it operates compared to the factory diverter valves, and other aftermarket products on the market. The factory diverter uses the solenoid to directly actuate the valve.
What to expect from your DV+ The DV+ is designed to offer three key improvements over the OE diverter: Longevity: The DV+ will outlast any version of the factory diverter. If you’ve ever replaced a factory diverter, chances are it won’t be your last. Fitting a DV+ is good insurance and pays for itself after one or two factory diverter replacements. Boost holding: The diaphragm type OE diverter valves typically seal well, until they begin to fail - which is not uncommon and almost assured on a tuned engine.
