Owner's Manual

Operating Your Computer 2-19
 For body worn operation, this device has been tested and meets FCC RF
exposure guidelines when positioned at 0 cm from the body. SAR
(Specific Absorption Rate) of the WLAN transmitter is 0.376W/kg (1g).
Your computer has a built-in Fn+F2 WLAN hot key to switch the WLAN
on/off. If you need to temporarily turn off the radio, press Fn+F2. To resume
network connection, press Fn+F2 again.
NOTE: Fn+F2 hot key works only when RF is set to ON in the OSD Control
Panel. (See “Using the OSD Control Panel” in Chapter 6.)
Connecting to a Wireless Network
To connect to a wireless network:
1. Make sure that the WLAN function is enabled (as described above). The
Wireless Network icon
on the taskbar should appear without a red
X.
2. Tap the Wireless Network icon on the taskbar. (An orange light in the
icon
indicates connections are available.)
3. In the list of available wireless networks, tap a network, and then tap
Connect.