Owner's Manual

Using BIOS Setup 5-15
NOTE:
 You can set the user password only when the supervisor password has
been set.
 If both the administrator and user passwords are set, you can enter any
of them for starting up the system and/or entering BIOS Setup.
However, the user password only allows you to view/change the settings
of certain items.
 A password setting is applied right after it is confirmed. To cancel a
password, leave the password empty by pressing the Enter key.
Password on Boot allows you to enable or disable the entering of password
for booting up your system. Once the password is successfully set and this
item is enabled, it is required for booting up the system.
Set HDD 0 Password sets the password for locking the Primary Master hard
disk drive. After setting a password, the hard disk drive can only be
unlocked by the password no matter where it is installed.
HDD 0 Password Is shows whether you have set the hard disk password.
TPM Setup Menu sets various TPM parameters. Press Enter to access the
submenu as shown below.
Security
TPM Setup Menu
Item Specific Help
TPM Support:
Current TPM State:
Change TPM Status:
[ ]
[Enabled and Activated]
[No Change]
This is used to
decide whether TPM
support should be
enabled or disabled.
F1 Help ↑↓ Select Item +/- Change Values F9 Setup Defaults
Esc Exit ←→ Select Menu Enter Select  Sub-Menu F10 Save and Exit
Enabled