User's Manual
Table Of Contents
- Table of Contents
- Getting Started
- Operating Your Computer
- Managing Power
- Expanding Your Computer
- Using BIOS Setup
- Using Getac Software
- Caring for the Computer
- Troubleshooting
- Preliminary Checklist
- Solving Common Problems
- Resetting the Computer
- System Recovery
- Appendix A
- Specifications
- Appendix B
- Regulatory Information
3-6
Managing Power
Replacing the Battery Pack
CAUTION:
There is danger of explosion if the battery is incorrectly replaced.
Replace the battery only with the computer manufacturer’s battery
packs. Discard used batteries according to the dealer’s instructions.
Do not attempt to disassemble the battery pack.
NOTE: You can hot swap one battery pack while the other one is supplying
the power.
To replace the battery pack, follow these steps:
1. Depending on which battery pack ( on the left side or on the right
side) you want to replace, open the respective cover.
Slide the cover latch toward the unlocked position ( ) (
) and then lift
up the tab (
) to release the cover.
(Battery 1 as the example)
2. Slide the battery latch toward the right to unlock.
CAUTION: To unlock or lock, always hold the battery latch itself to move it.
Never use the ribbon strip to pull the battery latch because this wrong
method can cause a broken strip or an incorrect battery pack installation.
(Battery 1 as the example)
3. Remove the battery pack out of the slot by pulling the ribbon strip.