User's Manual
Table Of Contents
- Table of Contents
- Getting Started
- Operating Your Computer
- Managing Power
- Expanding Your Computer
- Using BIOS Setup
- Using Getac Software
- Caring for the Computer
- Troubleshooting
- Preliminary Checklist
- Solving Common Problems
- Resetting the Computer
- System Recovery
- Appendix A
- Specifications
- Appendix B
- Regulatory Information
2-14
Operating Your Computer
Using the Network Features
Using the LAN
To connect the network cable to the LAN module, connect one end of the
LAN cable to the RJ-45 connector on the computer and the other end to the
network hub.
Using the Wireless LAN
The WLAN module of your computer supports IEEE 802.11a/b/g/n/ac.
Turning On/Off the WLAN Radio
To turn on the WLAN radio:
1. Make sure that the Airplane mode is switched off. You can control the
Airplane mode using one of the below methods.
• Press Fn+F1.
• Use the Airplane Mode button in the OSD Control Panel.
• For Windows 8: Open the Charms Bar, tap Settings Change PC
Settings Wireless. Slide the Airplane mode switch to the Off
position.
2. If you have previously turned off the WLAN radio, use one of the below
methods to turn it on.
• For Windows 8: Open the Charms Bar of Windows. Tap Settings
Change PC Settings Wireless. Slide the Wi-Fi switch to the On
position.