User's Manual

result show in Info windows at lower right corner. If it is right, it show
the <LF>W<OK><CR><LF>
1.9 P command:
1.9.1 The all operations are be locked the password. So we need use P
command before the other command operates.
1.9.2 Write the password (12345678) at Access Password item
1.9.3 Check the box【Set access to pre-command】
1.9.4 We can read TAG to get the EPC data.
1.9.5 We can see the information in Info windows at lower right corner. The
R command. It isn’t need the password to read EPC data. Because the
EPC data always can be read. But we need write the ECP data. If it
doesn’t run the P command, it will resend the error code (4). It means
the memory is locked. So we run the P command first and
immediately run W command. It can write data to EPC bank memory.
1.10 Kill command
1.10.1 Enter kill password 12345678 at Kill pwd item
1.10.2 Check the box【Kill】. The TAG will be kill and can’t be used again.
1.11 T command ---Select TAG operation