User's Manual
Table Of Contents
- Getting Started
- Basic Skills
- Managing Your Pocket PC
- _
- Microsoft Pocket Outlook
- _
- More Programs
- A
- Getting Connected
- Troubleshooting and Maintenance
- 1
- Regulatory Information
88
The manufacturer cannot be held responsible for modifications made by the User
and the consequences thereof, which may alter the conformity of the product with
the CE Mark.
FCC CAUTION
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
zThis device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designated to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiated radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
To avoid the possibility of exceeding the FCC radio frequency exposure limits,
human proximity to the antenna should be minimized. No metallic body
accessories are allowed and 1.5 cm spacing between PDA and the body must be
maintained to satisfy RF Exposure.
This PDA has been tested and demonstrated compliance when Bluetooth and
Wi-Fi are transmitting simultaneously. This PDA must not be co-located or
operating in conjunction with any other antenna or transmitter.
A2. Safety Precautions
About Charging