User's Manual
Table Of Contents
- 1 Introduction
- Table of Contents
- 2 Description (continued)
- 3 Physical Characteristics
- 4 ELECTRICAL SPECIFICATIONS
- 5 System Description
- 5.1 Power Supplies
- 5.2 Receiver – Analog Section
- 5.3 Register Descriptions
- 5.4 Direct Commands From MCU to Reader
- 5.4.1 Command Codes
- 5.4.2 Reset
- 5.4.3 Transmission With CRC
- 5.4.4 Transmission Without CRC
- 5.4.5 Delayed Transmission With CRC
- 5.4.6 Delayed Transmission Without CRC
- 5.4.7 Transmission Next Slot
- 5.4.8 Receiver Gain Adjust
- 5.4.9 Test External RF (RSSI at RX input with TX OFF)
- 5.4.10 Test Internal RF (RSSI at RX input with TX ON)
- 5.4.11 Block Receiver
- 5.4.12 Enable Receiver
- 5.5 Reader Communication Interface
- 5.6 Parallel Interface Communication
- 5.7 Serial Interface Communication
- 5.8 External Power Amplifier Application
TAPE AND REEL INFORMATION
*All dimensions are nominal
Device Package
Type
Package
Drawing
Pins SPQ Reel
Diameter
(mm)
Reel
Width
W1 (mm)
A0
(mm)
B0
(mm)
K0
(mm)
P1
(mm)
W
(mm)
Pin1
Quadrant
TRF7960RHBR QFN RHB 32 3000 330.0 12.4 5.3 5.3 1.5 8.0 12.0 Q2
TRF7960RHBT QFN RHB 32 250 180.0 12.4 5.3 5.3 1.5 8.0 12.0 Q2
TRF7961RHBR QFN RHB 32 3000 330.0 12.4 5.3 5.3 1.5 8.0 12.0 Q2
TRF7961RHBT QFN RHB 32 250 180.0 12.4 5.3 5.3 1.5 8.0 12.0 Q2
PACKAGE MATERIALS INFORMATION
www.ti.com 14-Jul-2012
Pack Materials-Page 1