User's Manual

B-6 Regulatory Information
On the Use of the RF Device
NOTE: The information in this section applies to models with the wireless LAN
module.
USA and Canada Safety Requirements and Notices
IMPORTANT NOTE:
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter, except in accordance with FCC
multi-transmitter product procedures. This equipment complies with FCC
RF exposure limits set forth for an uncontrolled environment. This device
was tested for typical laptop operations with the device contacted
directly to the human body to the back side of the tablet computer. To
maintain compliance with FCC RF exposure compliance requirements,
avoid direct contact to the transmitting antenna during transmitting.
Radio Frequency Interference Requirements and SAR
The FCC with its action in ET Docket 93-62 has adopted a safety standard
for human exposure to Radio Frequency (RF) electromagnetic energy
emitted by FCC certified equipment. The wireless LAN module meets the
Human Exposure limits found in OET Bulletin 65, 2001, and ANSI/IEEE C95.1,
1992. Proper operation of this radio according to the instructions found in
this manual will result in exposure substantially below the FCC’s
recommended limits. The following safety precautions should be
observed:
 Do not touch or move antenna while the unit is transmitting or
receiving.
 Do not hold any component containing the radio such that the
antenna is very close or touching any exposed parts of the body,
especially the face or eyes, while transmitting.
 Do not operate the radio or attempt to transmit data unless the
antenna is connected; if not, the radio may be damaged.