User's Manual
Table Of Contents
- 1 Device Overview
- Table of Contents
- 2 Revision History
- 3 Device Characteristics
- 4 Terminal Configuration and Functions
- 5 Specifications
- 6 Detailed Description
- 6.1 Overview
- 6.2 System Block Diagram
- 6.3 Power Supplies
- 6.4 Receiver – Analog Section
- 6.5 Receiver – Digital Section
- 6.6 Oscillator Section
- 6.7 Transmitter – Analog Section
- 6.8 Transmitter – Digital Section
- 6.9 Transmitter – External Power Amplifier and Subcarrier Detector
- 6.10 TRF7970A IC Communication Interface
- 6.11 Special Direct Mode for Improved MIFARE Compatibility
- 6.12 NFC Modes
- 6.13 Direct Commands from MCU to Reader
- 6.13.1 Command Codes
- 6.13.1.1 Idle (0x00)
- 6.13.1.2 Software Initialization (0x03)
- 6.13.1.3 Initial RF Collision Avoidance (0x04)
- 6.13.1.4 Response RF Collision Avoidance (0x05)
- 6.13.1.5 Response RF Collision Avoidance (0x06, n = 0)
- 6.13.1.6 Reset (0x0F)
- 6.13.1.7 Transmission With CRC (0x11)
- 6.13.1.8 Transmission Without CRC (0x10)
- 6.13.1.9 Delayed Transmission With CRC (0x13)
- 6.13.1.10 Delayed Transmission Without CRC (0x12)
- 6.13.1.11 Transmit Next Time Slot (0x14)
- 6.13.1.12 Block Receiver (0x16)
- 6.13.1.13 Enable Receiver (0x17)
- 6.13.1.14 Test Internal RF (RSSI at RX Input With TX ON) (0x18)
- 6.13.1.15 Test External RF (RSSI at RX Input with TX OFF) (0x19)
- 6.13.1.16 Receiver Gain Adjust (0x1A)
- 6.13.1 Command Codes
- 6.14 Register Description
- 7 Application Schematic and Layout Considerations
- 8 Device and Documentation Support
- 9 Mechanical Packaging and Orderable Information
