User's Manual
Table Of Contents
- 1 Device Overview
- Table of Contents
- 2 Revision History
- 3 Device Characteristics
- 4 Terminal Configuration and Functions
- 5 Specifications
- 6 Detailed Description
- 6.1 Overview
- 6.2 System Block Diagram
- 6.3 Power Supplies
- 6.4 Receiver – Analog Section
- 6.5 Receiver – Digital Section
- 6.6 Oscillator Section
- 6.7 Transmitter – Analog Section
- 6.8 Transmitter – Digital Section
- 6.9 Transmitter – External Power Amplifier and Subcarrier Detector
- 6.10 TRF7970A IC Communication Interface
- 6.11 Special Direct Mode for Improved MIFARE Compatibility
- 6.12 NFC Modes
- 6.13 Direct Commands from MCU to Reader
- 6.13.1 Command Codes
- 6.13.1.1 Idle (0x00)
- 6.13.1.2 Software Initialization (0x03)
- 6.13.1.3 Initial RF Collision Avoidance (0x04)
- 6.13.1.4 Response RF Collision Avoidance (0x05)
- 6.13.1.5 Response RF Collision Avoidance (0x06, n = 0)
- 6.13.1.6 Reset (0x0F)
- 6.13.1.7 Transmission With CRC (0x11)
- 6.13.1.8 Transmission Without CRC (0x10)
- 6.13.1.9 Delayed Transmission With CRC (0x13)
- 6.13.1.10 Delayed Transmission Without CRC (0x12)
- 6.13.1.11 Transmit Next Time Slot (0x14)
- 6.13.1.12 Block Receiver (0x16)
- 6.13.1.13 Enable Receiver (0x17)
- 6.13.1.14 Test Internal RF (RSSI at RX Input With TX ON) (0x18)
- 6.13.1.15 Test External RF (RSSI at RX Input with TX OFF) (0x19)
- 6.13.1.16 Receiver Gain Adjust (0x1A)
- 6.13.1 Command Codes
- 6.14 Register Description
- 7 Application Schematic and Layout Considerations
- 8 Device and Documentation Support
- 9 Mechanical Packaging and Orderable Information
TAPE AND REEL INFORMATION
*All dimensions are nominal
Device Package
Type
Package
Drawing
Pins SPQ Reel
Diameter
(mm)
Reel
Width
W1 (mm)
A0
(mm)
B0
(mm)
K0
(mm)
P1
(mm)
W
(mm)
Pin1
Quadrant
TRF7970ARHBR VQFN RHB 32 3000 330.0 12.4 5.3 5.3 1.5 8.0 12.0 Q2
TRF7970ARHBT VQFN RHB 32 250 180.0 12.4 5.3 5.3 1.5 8.0 12.0 Q2
PACKAGE MATERIALS INFORMATION
www.ti.com 15-Jan-2015
Pack Materials-Page 1