User's Manual

8-10 Troubleshooting
 Use the Web Manager/Telnet of the Access Point to check whether it
is connected to the network.
 Reconfigure and reset the Access Point.
I cannot access the network.
 Make sure that the necessary driver(s) is correctly installed.
 Make sure that the network configuration is appropriate.
 Make sure that the user name or password is correct.
 You have moved out of range of the network.
 Turn off power management.
Power Management Problems
The computer does not enter Sleep/Standby or Hibernation mode
automatically.
 If you have a connection to another computer, the computer does not
enter Sleep/Standby or Hibernation mode if the connection is actively
in use.
 Make sure that the Sleep/Standby or Hibernation time-out is enabled.
The computer does not enter Sleep/Standby or Hibernation mode
immediately.
 If the computer is performing an operation, it normally waits for the
operation to finish.
The computer does not resume from Sleep/Standby or Hibernation
mode.
 The computer automatically enters Sleep/Standby or Hibernation
mode when the battery pack is empty. Do any one of the following:
− Connect the AC adapter to the computer.
− Replace the empty battery pack with a fully charged one.