User's Manual
Intel® Centrino® Wireless-N 105 (Canyon Peak)
Intel® Centrino® Wireless-N 135 (Canyon Peak w/Bluetooth)
Intel® Centrino® Wireless-N 2200 (Marble Peak)
Intel® Centrino® Wireless-N 2230 (Jackson Peak 1)
Intel® Centrino® Advanced-N 6235 (Jackson Peak 2)
Hardware Specification, Rev. 2.2
Intel Confidential
473288
18
3.2.3 Ground (GND)
All ground pins are connected to a common ground bus that should be tied to system ground
via the connector.
3.3 Module level Power Consumption
3.3.1 Power Pins
Power consumption is measured on the following pins:
3.3V AUX: Pins 2, 24 (NC on card), 39, 41, and 52 are the same rail called Vaux.
Generation of PME, reporting status and enabling PME: The Mini Card uses a PME to request a
change from a power savings state (S3/S4) to the fully operational state (full power) ->
Wake-up Event (WoME).
Note: It is not allowed to connect active signals to the Mini Card input pins unless there
is a power supply provided to the power rails pins.
3.3.2 Power Consumption Definitions
Module power consumption: 3.3v rail power consumption.
Note: Power consumption numbers define the total consumed power, including 3.3v and
1.5v power rails (the 1.5v power rail is not in use).
Normal: unless stated otherwise, power consumption refers the highest averaged
power consumption value over any 1-second period.
Peak: The highest averaged value over any 10-millisecond period according to PCI
Express Mini Card Electromechanical Specification1.2.
3.3.3 Wi-Fi Power Consumption
Scale: MilliWatt (mW)
Meter: measured using Current Probe loop on the Power rails of the Mini-card (or Half Mini-
card interface/Pins)
The following tables provide product power consumption at 802.11 states. Power consumption
refers to the total consumed power, over 3.3v and 1.5v power rails (Note that the 1.5v Power
rail is not in use). Power consumption targets refer to all channels in all frequency bands for
both Netbook and Notebook supported platforms
Accuracy of power consumption values is as follows:
Values for the low power states are Mean values ±4mW.
Values for Tx and Rx power consumption are mean values ±5%.
Assumptions:
PCI-e ASPM (L1) is enabled.(Note that L0s is not used )
Transmit output power, is assumed to be 15dBm
Platform is running on Battery and Power Index is set to Max Power save (battery Life)
Table 5: Power Consumption – Wi-Fi States (mW)
Name
Description
Power Consumption Requirements (mW)
CyP
CyP+BT
JP1
JP2
MP
LB
LB
LB
LB
HB
LB
MM05/07
Mobile Mark
2005/2007 (Power
70
85
43
105
105
35