User's Manual

Using BIOS Setup and System Recovery 5-13
typing it again and pressing Enter. You can set the supervisor/user password
to be required for starting up the system and/or entering BIOS Setup.
Password on Boot allows you to enable or disable the entering of password
for booting up your system. Once the password is successfully set and this
item is enabled, it is required for booting up the system.
Set HDD 0 Password sets the password for locking the Primary Master hard
disk drive. After setting a password, the hard disk drive can only be
unlocked by the password no matter where it is installed.
HDD 0 Password Is shows whether you have set the hard disk password or
not.
TPM Setup Menu sets various TPM parameters. Press Enter to access the
submenu as shown below.
TPM Support
enables or disables TPM (Trusted Platform Module)
support. TPM (Trusted Platform Module) is a component on your
computer’s mainboard that is specifically designed to enhance platform
security by providing a protected space for key operations and other
security critical tasks.
Current TPM State
shows the current TPM state.
Security
TPM Setup Menu Item Specific Help
TPM Support:
Current TPM State:
Change TPM Status:
[ ]
[Disabled and Deactivated]
[No Change]
This is used to
decide whether TPM
support should be
enabled or disabled.
F1 Help
ɥɧ
Select Item +/- Change Values F9 Setup Defaults
Esc Exit
ɤɦ
Select Menu Enter Select
X
Sub-Menu F10 Save and Exit
Enabled