User's Manual

5-6 Using BIOS Setup and System Recovery

Wake Up Capability specifies events for waking up the system from S3 (Sleep)

state. Press Enter to access the submenu as shown below.

Advanced

Wake Up Capability

Item Specific Help

Any-key Wake Up From S3:

Ring Wake-Up From S3

USB Wake-Up From S3

[Disabled]

Allow any key to wake

up the system from

S3 (Sleep) state.

F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults

Esc Exit ←→ Select Menu Enter Select  Sub-Menu F10 Save and Exit

Any-key Wake Up From S3 allows any key to wake up the system from S3 (Sleep)

state.

Ring Wake-Up From S3 allows a modem activity to wake up the system from

S3 (Sleep) state.

USB Wake-Up From S3 allow a USB device activity to wake up the system from

S3 (Sleep) state.

System Policy sets the system performance. When set to

Performance

, the CPU always

runs at full speed. When set to

Balance

, the CPU speed changes according to the

current workload, therefore balancing between performance and power consumption.

AC Initiation sets if connecting AC power will automatically start or resume the system.

SATA Mode set to

AHCI

if your hard disk supports AHCI. AHCI allows you to take

advantage of Advanced Host Controller Interface features. The options are

IDE

and

AHCI

CAUTION: Incorrect SATA mode settings can result in hard disk drive boot failure.

Smart Card Power Management enables or disables power management for the smart

card module. When enabled, power to the module will be cut off after the smart

card slot has been empty for one minute.

Disabled