User's Manual

5-6 Using BIOS Setup and System Recovery
iRST Support enables of disables iRST, which gets your system up and running
faster.
Wake Up Capability
Wake Up CapabilityWake Up Capability
Wake Up Capability specifies events for waking up the system. Press Enter
Enter Enter
Enter to access
the submenu as shown below.
Advanced
Wake Up Capability Item Specific Help
Ring Wake Up From S3:
USB Wake Up From S3:
Wake on PCH LAN:
[Disabled]
[Disabled]
[Disabled]
Allow a modem
activity to wake up
the system from
S3(Sleep) state.
F1 Help ĖĘ
ĖĘĖĘ
ĖĘ Select Item +/- Change Values F9 Setup Defaults
Esc Exit ĕė
ĕėĕė
ĕė Select Menu Enter Select 

 Sub-Menu F10 Save and Exit
Ring Wake Up From S3 allows a modem device activity to wake up the system
from S3 (Sleep) state.
USB Wake Up From S3 allows a USB device activity to wake up the system from
S3 (Sleep) state.
Wake on PCH LAN allows a LAN activity to wake up the system from S3 (Sleep)
state.
System Policy
System Policy System Policy
System Policy sets if the system always runs at full speed (
Performance ) or lowers
down when its temperature is too high (
Balance ).
AC Initiation
AC Initiation AC Initiation
AC Initiation sets if connecting AC power will automatically start or resume your
computer.
SATA Mode
SATA ModeSATA Mode
SATA Mode set to
AHCI if your hard disk supports AHCI. AHCI allows you to take
advantage of Advanced Host Controller Interface features. The options are
IDE and
AHCI .
CAUTION: Incorrect SATA mode settings can result in hard disk drive boot failure.
Disabled