User's Manual

2-14 Operating Your Computer
Term
TermTerm
Term Action
ActionAction
Action
Move Move the cursor pointed by the digitizer pen.
Click/Point Tap gently on the display.
Double-click Tap twice on the display rapidly.
Drag and
drop
Tap lightly on the display and move your
digitizer pen until you reach your destination
(drag). Finally, release your digitizer pen
(drop) when you finish dragging your
selection to the destination. The object will
drop into the new location.
Right-click Press and hold down the digitizer pen button
(A), then tap gently the object.
CAUTION:
 When the LCD display is used alone or with an external display
simultaneously, the digitizer function cannot be used when the area of either
display is set larger than the default setting of the display resolution.
 Even when only an external display is in use, the cursor will move on the
external display if you touch the surface of the LCD display with the pen or
bring the pen close to the surface of the LCD display when the digitizer driver is
active. Therefore, do not touch the LCD display when only an external display
is in use.
 The active digitizer feature cannot be used in the BIOS Setup program or
when using the full screen in DOS mode.