User's Manual

2-16
Operating Your Computer
Term Action
Move
Move the cursor pointed by the digitizer
pen.
Click/Point
Tap gently on the display.
Double-clic
k
Tap twice on the display rapidly.
Drag and
drop
Tap lightly on the display and move
your digitizer pen until you reach your
destination (drag). Finally, release your
digitizer pen (drop) when you finish
dragging your selection to the
destination. The object will drop into the
new location.
Right-click
Press and hold down the digitizer pen
button (A), then tap gently the object.
CAUTION:
 When the LCD display is used alone or with an external display
simultaneously, the digitizer function cannot be used when the area of either
display is set larger than the default setting of the display resolution.
 Even when only an external display is in use, the cursor will move on the
external display if you touch the surface of the LCD display with the pen or
bring the pen close to the surface of the LCD display when the digitizer driver
is active. Therefore, do not touch the LCD display when only an external
display is in use.
 The active digitizer feature cannot be used in the BIOS Setup program or
when using the full screen in DOS mode.