User Manual

Setup Configuration Utility 5-12
SCU Password
Set Password allows you to set the password for your system. When
typing password, first make sure that Num Lock is off, then type your
password in the entry fields and press Enter. Confirm your password by
typing it again and pressing Enter. If the Enable Password to SCU
sub-item is enabled, the set password is always required to enter SCU.
Hard Disk Boot Sector sets if a warning message will appear when
the hard disk boot sector (partition table) has been changed. A check
mark (ΓΌ) indicates enabled, while an underline (_) indicates disabled.
The default setting is disabled.
CAUTION: sets this item to disabled before installing an operating system, running
Fdisk or Format program. Otherwise, the intended action will fail.