User Manual

SetupConfiguration Utility
3-2
1. All the SCU screens shown in this chapter are examples.
Your actual settings may vary from those shown here.
2. The SCU program may have been updated after this manual
was published.
To run SCU, press F2 when the prompt appears in the left corner of the screen
during system startup. The prompt shows up on the screen for only a few
seconds. You must press F2 quickly. The SCU menu appears as shown next.
3-2.1 Main
This section describes the main items of the SETUP program.
The SCU screen can be divided into four areas:
? On the top line of the screen is the menu bar, which lists the titles of
the available menus. Each menu title contains a pull-down menu,
which displays items for setting.
? The left column of the screen displays the current configuration
information of the system. If an item in the pull-down menu is
selected which contains multiple choices, the left column displays the
submenu where you can make your selections.
Setup Menu