User Manual

Operation
2
-
6
2-3.3 Floppy Disk Drive/CD-ROM/DVD/COMBO/DVD RW
Bay 1 on the A770 can contain either a removable floppy disk dirve, a
removeable CD-ROM, a removeable DVD module or an auxiliary battery
pack.
1. Turn the A770 “Off”.
2. Open the Bay 1 access door. (See Fig 2-5)
3. Push down on the “Eiject” handle at the bottom of the FDD/CD-ROM
/DVD/COMBO/DVD RW compartment. Then FDD/CD-ROM/DVD
/COMBO/DVD RW module will spring back about 0.4 cm.
4. Pull the handle outwards about 3 cm. Do not force it out any further as it
might damage the unit.
5. Using both hands, gentlly slide the entire FDD/CD-ROM/DVD/COMBO
/DVD RW module out form the bay 1 compartment.
2-3.3.1 Replace the FDD/CD-ROM/DVD/COMBO/DVD RW:
Using both hands, gentlly insert the FDD/CD-ROM/DVD/COMBO
/DVD RW module back into the bay 1 compartment. Continue to slide it in
unti it seats firmly in place. Be sure to closed and secure the bay 1 access
door when not in use.
7. Turn the power back “On” to the A770.
NOTE
Do not “Hot Swap” the FDD/CD-ROM/DVD/COMBO
/DVD RW module. The A770 is not PnP (Plug and Play)
ready.