Operation Manual

MD60LOG User Manual rev. 05

ENGLISH

NOTE: during the creation of the track, it is not necessary to define all of the intermediate positions.

If just the (FINISH LINE) is needed it is enough to press the S (SET) button when the display

visualises the message LINE 1: in this condition upon the next passage over the finish line the

instrument will begin to read the lap times.

If only 2 split points and a finish line are needed, user can press the S button when the display show

LINE3:

11.2 CREATION OF A CUSTOM TRACK IN LINEAR MODALITY

If you want create a custom track in LINEAR modality (suitable for open circuits like car/bike dragster

competitions ), please verify that the TRACK MODE option in OPTIONS menù is set as LINEAR.

Please note: the starting point position will be automatically calculated when the vehicle starts

running. Beware: if the first split point is too near the starting point the MD60 LOG can’t be display

the first split time.

After this check follow the procedure described at the next chapter.

11.2.1 Starting line and intermediate times definition

In the event that the track desired is not in the unit's library, or you wish to create a new one with different

settings from those present in the memory of the MD60, proceed in the following manner:

• Make sure that there is adequate satellite coverage (the unit must be locked on to at least 5 satellites).

• From the CHRONO screen, briefly pressing the S (SET) button, enter the main menu and select the

submenu TRACK pressing the S button briefly. Scroll the page with the ARROW button and briefly

pressing the S (SET) button select the item CREATE NEW.

The LINE 1 item will appear on the CHRONO screen indicating the create track mode.





LOAD F

ROM LIBRARY

CREATE NEW

DELETE TRACK

<<EXIT





LINE 1 (SPLIT1)

LINE 2 (SPLIT 2)

LINE 3 (FL)