Operation Manual

MD60LOG User Manual rev. 05

ENGLISH

11 CREATION OF A CUSTOM TRACK

11.1 CREATION OF A CUSTOM TRACK IN LOOP MODALITY

If you want create a custom track in LOOP modality (suitable for closed circuits like car/bike speed way or

motocross ), please verify that the TRACK MODE option in OPTIONS menù is set as LOOP.

After this check follow the procedure described at the next chapter.

11.1.1 Starting line and intermediate times definition

In the event that the track desired is not in the unit's library, or you wish to create a new one with different

settings from those present in the memory of the MD60, proceed in the following manner:

• Make sure that there is adequate satellite coverage (the unit must be locked on to at least 5 satellites).

• From the CHRONO screen, briefly pressing the S (SET) button, enter the main menu and select the

submenu TRACK pressing the S button briefly. Scroll the page with the ARROW button and briefly

pressing the S (SET) button select the item CREATE NEW.

The LINE 1 item will appear on the CHRONO screen indicating the create track mode.

• Upon passing the first intermediate time desired (in the case of closed or open circuits), press the

ARROW button: the unit will record the GPS coordinates of the point just defined and will prepare to

memorise the next, showing the message, LINE 2. The length of the transversal finish line set will be

defined by the value associated with the parameter FL LENGTH (see chap. 10.4)

• Upon passing the next intermediate point press the ARROW to memorise its position. The unit will

prepare for the next intermediate line displaying the message, LINE3. It is possible to continue with the

same procedure until arriving at the last intermediate line available (LINE4).

• Once the finish line position (LINE5) has been defined by pressing the S (SET) button: the unit will then

return to the time measurements page.

• Make sure that the chrono start running (by passing the speed threshold defined on START SPEED

option): this condition it’s necessary to allow the saving custom track procedure.

• In these conditions it is possible to start a test session or to save the track just created in the unit's

archive (see chap.11.