Operation Manual

DATA MANAGER - GET DATA ACQUISITION SOFTWARE rev. 01

ENGLISH

6.5.2 “WATCH” channel calibration

Calibration is necessary to convert signals from sensors to comprehensible data.

This operation can be done during the channel creation (read previous chapters) or in WATCH window,

clicking on Calibrate button (corresponding to the required channel) without starting WATCH .

We suggest to use this function only after the channel is configured in M40 setup.

Once the button Calibrate is pressed, you will see the calibration window. The procedures are the same of

previous chapters.

Once the channel is calibrated, you need to send again the setup to the device. You can do this

directly from WATCH selecting “Send Setup to Device” in File menu o by clicking the icon (second

from the left in instrument bar).