Operation Manual

D30 EVO DASH rev. 1.0

ENGLISH

 Make sure that the programming connector (included in the cable) is disconnected (if you do not intend to

programme the dashboard).

 Turn the D30EVO dashboard on.

 Check the correct connection of the dashboard to the PC clicking the Get ECU Codes control (included in

the Communication menu). If communication is established correctly, you will see a window including

the codes in the memory of the connected dashboard.

NOTE: this operation is not required for the connection between the dashboard and the PC, but it

is useful in order to check the correct performance of cable connections and the setup of the

MAYA communication port.

CAUTION: THE SHOWED CODES ARE USEFUL FOR IDENTIFYING THE DEVICE TYPE OF THE

DASHBOARD CONNECTED TO THE PC.

If the dashboard device is not known, it is enough to load a random one in the Maya in order to

receive some answer from the central office.

INSERT ONLY FOR

PROGRAMMING