Installation Instructions

Table Of Contents

Just Show It

Now, Let’s Get Started

hand unit.

Press the gesture button on the remoter to display the corresponding gesture

light of the HAND LIGHT and resume the cover.(If the hand unit does not light

up, roll the battery around

1. Insert 3V Lithium battery in the battery compartment on the back of Geshowit

)

2. Clean the area where you would like to stick your hand light.(If the surface is

freezing cold, please DO NOT attach the hand unit)

3. Tear off the tape’s cover of the hand unit and remote, and place them to your

desired places.

Please place your remoter on a safe location that is convenient to control while

driving according to your wants.

4. The Battery of the remote is repeable. Pop the back cover of the remote open

with the accompanying pin through the slot, then we can replace the CR2032

battery.

PAGE 1
Just Show It Now, Let’s Get Started 1. Insert 3V Lithium battery in the battery compartment on the back of Geshowit hand unit. Press the gesture button on the remoter to display the corresponding gesture light of the HAND LIGHT and resume the cover.(If the hand unit does not light up, roll the battery around) 2. Clean the area where you would like to stick your hand light.(If the surface is freezing cold, please DO NOT attach the hand unit) 3.
PAGE 2
FCC Requirement Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.