User's Manual

ManualsBrandsGEP TECHNOLOGY ManualsAudio EquipmentBluetooth Portable Speaker

Parts:

Charge:

Initial set up via Bluetooth

1. Turn on the Bluetooth™ Speaker by pressing up top control panel.and slide shift button to bluetooth icon.

2. Wait for approximately 20 seconds,the speaker will go into pairing mode and will produce a “beep”tone.The top red and blue led light will alternately flash.

3. Turn on a device such as an ipod,iphone or mp3 device and go to:Setting>General>Bluetooth.Click on the bluetooth GP-503 will then appear on the device.Click on the GP-503. The device is now connected and paired with the speaker.If the device prompts for a pair

code,enter:”0000”

4. If pairing is not successful within 150seconds,the system will search for the last paired device.To restart the pairing process,turn off the speaker and repeat step 1.If the initial set up connection is succesful,the next time the speaker is turned on,the speaker will

automatically pair to the last device it was connected with.

5. GP-503 don't have volume control function,please adjust volume via music device.

NOTE:

1. The bluetooth speaker only connects to one device at a time.Turn off the bluetooth speaker in order to pair the device with another bluetooth device.

2. The maximum transmission between the bluetooth speaker and a device is 10 meters or 32 feet.

3. Interference may occur during playback when using the bluetooth function near other wireless devices.If playback through bluetooth is problematic,move the bluetooth speaker

and the playback device to a different location,or use the 3.5mm audio cable jack instead of the bluetooth function.

WARNING:

The built-in rechargeable battery is not replaceable.Do not remove or replace battery.Dispose of unit properly.Do not dispose unit in trash or fire.

BLUE TOOTH SPEAKER MANUAL

1,USB charge port

2,Shift button

Fully charge the speaker before use.

Connect the speaker to the PC C via provided USB cable.

It is powered by internal rechargeable battery and it can using the converting cable for charging function by

USB port. When the top RED LED flash approximately 15 times, it means the battery is low, please recharge the speaker. The solid RED LED will appear when speaker

is on charged. The RED LED goes out when charge is finished

Summary of content (3 pages)

PAGE 1
BLUE TOOTH SPEAKER MANUAL Parts: Charge: 1,USB charge port 2,Shift button Fully charge the speaker before use. Connect the speaker to the PC C via provided USB cable. It is powered by internal rechargeable battery and it can using the converting cable for charging function by USB port. When the top RED LED flash approximately 15 times, it means the battery is low, please recharge the speaker. The solid RED LED will appear when speaker is on charged.
PAGE 2
Specification Connecting with an audio cable To slide shift button to audio input icon and connect the bottom extented 3.5mm audio jack to music device. Output:： 2.5Wx1pcs Signal To Noise Ratio: Frequency Response: Distortion: Battery Li-ion: Battery Capacity: Battery Charging Voltage: Charger Time: Last Time: Last Time: Driver Unit: Dimension: Power Indicator Light: Transmission Distance: Work Frequency: Bluetooth Model: Transmission distance: Transmission Power: >86dB 100Hz-20kHz <10% 3.
PAGE 3
FCC Statement NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.