Quick Start Guide

12
Connecting Hardware Watchdog
Insert the Hardware Watchdog Jumper Wire to the 2-pin connectors on the Card. The (+) pin
on the Card must connect to the Reset (+) pin on the motherboard, and the (-) pin on the
Card to the Ground (-) pin on the motherboard. Ensure the connection is correct; otherwise
the hardware watchdog will not work.
+-
+-
PWSW
LEDHDD
RST
+
_
Motherboard Front
Panel Jumper
PC Reset Switch
GV-5016 Card
Hardware Watchdog
Figure 1-11
Note: To locate the motherboard’s Reset (+) pin and (-) pin, please refer to the
motherboard’s user manual.