Quick Installation Guide

Introduction

The frame rate limit is based on the resolution of video sources. The higher video

resolutions, the lower frame rates you can assign to a single hard disk. In other words,

the higher frame rates you wish to record, the more hard disks you need to install. For

the information of recording frame rates, you may consult the user’s manual of the IP

camera that you wish to connect to.

Installing GV-VMS

1. To download GV-VMS, go to the Software Download and Upgrading page of GeoVision

Website: http://www.geovision.com.tw/english/5_8_VMS.asp

2. To install GV-VMS, find the Primary Applications section under the Video Management

Software tab and click the Download icon

of GV-VMS.

3. Double-click GVVMSInstaller.exe and follow the instructions in the wizard to complete

installation.

4. If you are using a USB dongle, insert the dongle to your computer. The GV-USB dongle is

needed if you want to connect to more than 32 channels of IP devices or to third-party IP

devices.

5. To install USB driver, find the Driver section under the Video Management Software tab,

and click the Download icon

of GV-USB Devices Driver.

Figure 1-1

If you are using the GV-USB dongle, verify that the driver is installed correctly after the steps

above. Go to Windows Device Manager and expand DVR-Devices. You should see the GV-

Series USB Protector.

Figure 1-2