Quick Installation Guide

Camera Setup
3
3.2 Configuring Camera Settings
To configure camera settings such as codec and frame rates, click the Setup button of an
active camera in the IP Device List (Home
> Toolbar > Configure > Camera
Install). The settings available vary depending on the camera’s firmware and whether the
camera is connected.
There are three setup dialog boxes in the left menu of the camera’s setting dialog box: Video
Setting, Audio Setting, and General Setting. Clicking the Finger button
will apply the
setting to all the cameras.
[Video Setting]
In Video Setting, you can configure the camera name, codec, frame rate, GOP, bitrate,
resolution and video attributes of the camera. Note that changes made to the Video Setting
dialog box will change the settings on the IP camera.
Set video attributesSet camera name
Set codec
and FPS
Figure 3-2
15