Installation Guide

56
C. Thread the cable through the conduit entry at the bottom of the back cover and
follow step 2A-3 and 2A-4 to secure the camera body.
3. Assemble the camera with the mounting plates.
A. Thread the camera cable through the mounting plates.
B. Slide the 30 mm M8 screws (GV-Mount310, No. 2) from the front and secure from
the backside using plain washer (GV-Mount310, No. 3), split washer, (GV-Mount310,
No. 4) and M8 screw cap (GV-Mount310, No. 5).
Front View
Back View
4. Secure the plates to the wall with 8 self-prepared screws.
5. Refer to the indicated sections of the GV-IPCam H.264 User’s Manual on the software
CD to:
A. Connect the network, power and other cables to the camera. See 10.5 Connecting
the Camera.
B. Access the live view. See 14.1 Accessing the Live View.
C. Adjust the angle, focus and zoom of the camera. See steps 9 and 10 in 10.4.1 Hard-
Ceiling Mount.
D. Secure the thread lock, replace the silica gel bag and secure the housing cover. See
steps 11 to 13 in 10.4.1 Hard-Ceiling Mount.
Note: You can use a corrugated tube to waterproof the cable.