Installation Guide
Table Of Contents
- GV-Mount Accessories Installation Guide(MT-E-EN)
- GV-Mount Accessories Installation Guide
- Copyright
- Contents
- Installation Overview
- Required Accessories
- Note for Installing Camera Outdoor
- Note for Adjusting Focus and Zoom
- Note for Closing the Bullet Camera Cover
- Note for Supported Power BoxTypes
- 1. Introduction
- 2. Installing the Vandal Proof IP Dome
- 2.1 Assembling the Vandal Proof IP Dome with the dome housing
- 2.3 Straight Tube Mount
- 2.4 L-Shaped Wall Mount
- 2.5 Wall Box Mount
- 2.6 Wall Pendant Mount
- 2.7 Convex Corner Mount with Pendant Tube
- 2.8 Convex Corner Mount with Wall Bracket
- 2.9 Convex Corner Box Mount
- 2.10 Concave Corner Mount with Pendant Tube
- 2.11 Concave Corner Mount with Wall Bracket
- 2.12 Pole Mount with Pendant Tube
- 2.13 Pole Mount with Wall Bracket
- 2.14 Pole Box Mount
- 3. Installing the Fixed IP Dome
- 4. Installing the Fisheye Camera
- 5. Installing the GV-SD220/220-S IP Speed Dome
- 6. Installing the Bullet Camera
- 7. Installing the Arctic Box Camera
- 8. Installing the Mini Fixed Dome
- 9. Installing the Mini Fixed Rugged Dome
- GV-Mount Accessories Installation Guide
Installing the Vandal Proof IP Dome
49
2
1. Assemble the camera with the dome housing. See 2.1 Assembling the Vandal Proof IP
Dome with the Dome Housing.
2. Assemble the mounting plates (GV-Mount300, No. 1), slide in the plain washer (GV-
Mount300, No. 4), then the split washer (GV-Mount300, No. 5), and secure them with the
screw cap (GV-Mount300, No. 6).
3. Secure the junction box (GV-Mount203, No. 1) to the plate from the backside using the
25 mm M8 screw (GV-Mount300, No. 3), plain washer (GV-Mount300, No. 4) and split
washer (GV-Mount300, No. 5).
Back View
4. Secure the plates to the wall with 8 self-prepared screws. Face the conduit exit
downward.