Installation Guide
Table Of Contents
- GV-Mount Accessories Installation Guide(MT-E-EN)
- GV-Mount Accessories Installation Guide
- Copyright
- Contents
- Installation Overview
- Required Accessories
- Note for Installing Camera Outdoor
- Note for Adjusting Focus and Zoom
- Note for Closing the Bullet Camera Cover
- Note for Supported Power BoxTypes
- 1. Introduction
- 2. Installing the Vandal Proof IP Dome
- 2.1 Assembling the Vandal Proof IP Dome with the dome housing
- 2.3 Straight Tube Mount
- 2.4 L-Shaped Wall Mount
- 2.5 Wall Box Mount
- 2.6 Wall Pendant Mount
- 2.7 Convex Corner Mount with Pendant Tube
- 2.8 Convex Corner Mount with Wall Bracket
- 2.9 Convex Corner Box Mount
- 2.10 Concave Corner Mount with Pendant Tube
- 2.11 Concave Corner Mount with Wall Bracket
- 2.12 Pole Mount with Pendant Tube
- 2.13 Pole Mount with Wall Bracket
- 2.14 Pole Box Mount
- 3. Installing the Fixed IP Dome
- 4. Installing the Fisheye Camera
- 5. Installing the GV-SD220/220-S IP Speed Dome
- 6. Installing the Bullet Camera
- 7. Installing the Arctic Box Camera
- 8. Installing the Mini Fixed Dome
- 9. Installing the Mini Fixed Rugged Dome
- GV-Mount Accessories Installation Guide
28
1. Assemble the camera to the dome housing. See 2.1 Assembling the Vandal Proof IP
Dome with the Dome Housing.
2. Assemble the tube (GV-Mount100, No. 3) and the tube connector (GV-Mount100, No. 4).
3. Thread the camera cable through the tube and secure the tube to the end of the housing
cap (GV-Mount901, No. 2) with M6 screws (GV-Mount901, No. 4).
4. Thread the camera cable through the box cover (GV-Mount100, No. 2), assemble the box
cover and the tube, and tighten the torxes using the torx wrench (GV-Mount100, No. 7).