Installation Guide
Table Of Contents
- GV-Mount Accessories Installation Guide(MT-E-EN)
- GV-Mount Accessories Installation Guide
- Copyright
- Contents
- Installation Overview
- Required Accessories
- Note for Installing Camera Outdoor
- Note for Adjusting Focus and Zoom
- Note for Closing the Bullet Camera Cover
- Note for Supported Power BoxTypes
- 1. Introduction
- 2. Installing the Vandal Proof IP Dome
- 2.1 Assembling the Vandal Proof IP Dome with the dome housing
- 2.3 Straight Tube Mount
- 2.4 L-Shaped Wall Mount
- 2.5 Wall Box Mount
- 2.6 Wall Pendant Mount
- 2.7 Convex Corner Mount with Pendant Tube
- 2.8 Convex Corner Mount with Wall Bracket
- 2.9 Convex Corner Box Mount
- 2.10 Concave Corner Mount with Pendant Tube
- 2.11 Concave Corner Mount with Wall Bracket
- 2.12 Pole Mount with Pendant Tube
- 2.13 Pole Mount with Wall Bracket
- 2.14 Pole Box Mount
- 3. Installing the Fixed IP Dome
- 4. Installing the Fisheye Camera
- 5. Installing the GV-SD220/220-S IP Speed Dome
- 6. Installing the Bullet Camera
- 7. Installing the Arctic Box Camera
- 8. Installing the Mini Fixed Dome
- 9. Installing the Mini Fixed Rugged Dome
- GV-Mount Accessories Installation Guide
170
GV-Mount913
Type of Power Box
Hole
4’’ Square
A
Double Gang
B
4’’ Octagon
C
Single Gang
D
A
A
B B
C C
D
D
B
B
C
C
A
A
EFD
EFD
UFDUFD
FD FD
MFD
MFD
MDR
MDR
2. Open the camera cover with the supplied torx wrench.
3. Thread the camera cable through the mounting plate and the power box, and secure the
camera to the mounting plate with M3 screws (GV-Mount910 or GV-Mount913, No. 2).
Use the holes indicated with “MDR”.
4. Refer to the indicated sections of the GV-IPCam H.264 User’s Manual on the software
CD to:
A. Waterproof the cable with the supplied cable connector. See step 6 in 5.4.2 GV-
MDR Series.
B. Connect the network and power to the camera.
C. Access the live view. See 14.1 Accessing the Live View.