Installation Guide
Table Of Contents
- GV-Mount Accessories Installation Guide(MT-E-EN)
- GV-Mount Accessories Installation Guide
- Copyright
- Contents
- Installation Overview
- Required Accessories
- Note for Installing Camera Outdoor
- Note for Adjusting Focus and Zoom
- Note for Closing the Bullet Camera Cover
- Note for Supported Power BoxTypes
- 1. Introduction
- 2. Installing the Vandal Proof IP Dome
- 2.1 Assembling the Vandal Proof IP Dome with the dome housing
- 2.3 Straight Tube Mount
- 2.4 L-Shaped Wall Mount
- 2.5 Wall Box Mount
- 2.6 Wall Pendant Mount
- 2.7 Convex Corner Mount with Pendant Tube
- 2.8 Convex Corner Mount with Wall Bracket
- 2.9 Convex Corner Box Mount
- 2.10 Concave Corner Mount with Pendant Tube
- 2.11 Concave Corner Mount with Wall Bracket
- 2.12 Pole Mount with Pendant Tube
- 2.13 Pole Mount with Wall Bracket
- 2.14 Pole Box Mount
- 3. Installing the Fixed IP Dome
- 4. Installing the Fisheye Camera
- 5. Installing the GV-SD220/220-S IP Speed Dome
- 6. Installing the Bullet Camera
- 7. Installing the Arctic Box Camera
- 8. Installing the Mini Fixed Dome
- 9. Installing the Mini Fixed Rugged Dome
- GV-Mount Accessories Installation Guide
168
5. Thread the cable through the wall mount bracket and secure the camera to the wall
mount bracket with two M3 screws (GV-Mount909, No. 4). Use the labels on the wall
mount bracket to help you.
6. Refer to the indicated sections of the GV-IPCam H.264 User’s Manual on the software
CD to:
A. Waterproof the cable with the supplied cable connector. See step 6 in 5.4.2 GV-
MDR Series.
B. Connect the network and power to the camera.
C. Access the live view. See 14.1 Accessing the Live View.
D. Based on the live view, adjust the angle of the camera. See steps 8 in 5.4.2 GV-
MDR Series.
E. Replace the silica gel bag and secure the camera’s cover with the supplied torx
wrench.