Installation Guide
Table Of Contents
- GV-Mount Accessories Installation Guide(MT-E-EN)
- GV-Mount Accessories Installation Guide
- Copyright
- Contents
- Installation Overview
- Required Accessories
- Note for Installing Camera Outdoor
- Note for Adjusting Focus and Zoom
- Note for Closing the Bullet Camera Cover
- Note for Supported Power BoxTypes
- 1. Introduction
- 2. Installing the Vandal Proof IP Dome
- 2.1 Assembling the Vandal Proof IP Dome with the dome housing
- 2.3 Straight Tube Mount
- 2.4 L-Shaped Wall Mount
- 2.5 Wall Box Mount
- 2.6 Wall Pendant Mount
- 2.7 Convex Corner Mount with Pendant Tube
- 2.8 Convex Corner Mount with Wall Bracket
- 2.9 Convex Corner Box Mount
- 2.10 Concave Corner Mount with Pendant Tube
- 2.11 Concave Corner Mount with Wall Bracket
- 2.12 Pole Mount with Pendant Tube
- 2.13 Pole Mount with Wall Bracket
- 2.14 Pole Box Mount
- 3. Installing the Fixed IP Dome
- 4. Installing the Fisheye Camera
- 5. Installing the GV-SD220/220-S IP Speed Dome
- 6. Installing the Bullet Camera
- 7. Installing the Arctic Box Camera
- 8. Installing the Mini Fixed Dome
- 9. Installing the Mini Fixed Rugged Dome
- GV-Mount Accessories Installation Guide
Installing the Mini Fixed Dome
159
8
4. Hang the wall mount bracket on the wall mount screws and push the wall mount bracket
downward. Tighten the wall mount screws to the wall.
5. Unscrew the camera’s cover using the supplied torx wrench.
6. Align and secure the camera to the wall mount bracket with two M3 screws (No. 4, GV-
Mount900).
7. Refer to the indicated sections of the GV-IPCam H.264 User’s Manual on the software
CD to:
A. Connect the network, power and other cables to the camera. See 5.5 Connecting
the Camera.
B. Access the live view. See 14.1 Accessing the Live View.
C. Based on the live view, adjust the pan and tilt angles and secure the housing cover
with the torx wrench. See steps 7 in 5.4.1 GV-MFD Series.