Installation Guide
Table Of Contents
- GV-Mount Accessories Installation Guide(MT-E-EN)
- GV-Mount Accessories Installation Guide
- Copyright
- Contents
- Installation Overview
- Required Accessories
- Note for Installing Camera Outdoor
- Note for Adjusting Focus and Zoom
- Note for Closing the Bullet Camera Cover
- Note for Supported Power BoxTypes
- 1. Introduction
- 2. Installing the Vandal Proof IP Dome
- 2.1 Assembling the Vandal Proof IP Dome with the dome housing
- 2.3 Straight Tube Mount
- 2.4 L-Shaped Wall Mount
- 2.5 Wall Box Mount
- 2.6 Wall Pendant Mount
- 2.7 Convex Corner Mount with Pendant Tube
- 2.8 Convex Corner Mount with Wall Bracket
- 2.9 Convex Corner Box Mount
- 2.10 Concave Corner Mount with Pendant Tube
- 2.11 Concave Corner Mount with Wall Bracket
- 2.12 Pole Mount with Pendant Tube
- 2.13 Pole Mount with Wall Bracket
- 2.14 Pole Box Mount
- 3. Installing the Fixed IP Dome
- 4. Installing the Fisheye Camera
- 5. Installing the GV-SD220/220-S IP Speed Dome
- 6. Installing the Bullet Camera
- 7. Installing the Arctic Box Camera
- 8. Installing the Mini Fixed Dome
- 9. Installing the Mini Fixed Rugged Dome
- GV-Mount Accessories Installation Guide
Installing the Arctic Box Camera
155
7
2. Assemble the camera with the mounting plates.
A. Thread the camera cable through the mounting plates.
B. Slide the 30 mm M8 screws (GV-Mount310, No. 2) from front and secure from the
backside using plain washer (GV-Mount310, No. 3), split washer (GV-Mount310,
No. 4) and screw cap (GV-Mount300, No. 5).
Front View
Back View
3. Secure the plates to the wall with 8 self-prepared screws.
4. Refer to the indicated sections of the GV-IPCam H.264 User’s Manual on the software
CD to:
A. Connect the camera to PoE. See 4.5 Connecting the Camera.
B. Access the live view. See 14.1 Accessing the Live View.
C. Adjust the angle, focus and zoom of the camera. See steps 6 and 7 in 4.4
Installation.
D. Replace the silica gel bag and secure the housing cover. See steps 8 and 9 in 4.4
Installation.