Installation Guide
Table Of Contents
- GV-Mount Accessories Installation Guide(MT-E-EN)
- GV-Mount Accessories Installation Guide
- Copyright
- Contents
- Installation Overview
- Required Accessories
- Note for Installing Camera Outdoor
- Note for Adjusting Focus and Zoom
- Note for Closing the Bullet Camera Cover
- Note for Supported Power BoxTypes
- 1. Introduction
- 2. Installing the Vandal Proof IP Dome
- 2.1 Assembling the Vandal Proof IP Dome with the dome housing
- 2.3 Straight Tube Mount
- 2.4 L-Shaped Wall Mount
- 2.5 Wall Box Mount
- 2.6 Wall Pendant Mount
- 2.7 Convex Corner Mount with Pendant Tube
- 2.8 Convex Corner Mount with Wall Bracket
- 2.9 Convex Corner Box Mount
- 2.10 Concave Corner Mount with Pendant Tube
- 2.11 Concave Corner Mount with Wall Bracket
- 2.12 Pole Mount with Pendant Tube
- 2.13 Pole Mount with Wall Bracket
- 2.14 Pole Box Mount
- 3. Installing the Fixed IP Dome
- 4. Installing the Fisheye Camera
- 5. Installing the GV-SD220/220-S IP Speed Dome
- 6. Installing the Bullet Camera
- 7. Installing the Arctic Box Camera
- 8. Installing the Mini Fixed Dome
- 9. Installing the Mini Fixed Rugged Dome
- GV-Mount Accessories Installation Guide
Installing the Fisheye Camera
119
4
3. Secure the mounting bracket to the pole using 3 steel straps (GV-Mount400 / GV-
Mount410, No. 2). Rotate the screw on the strap to adjust its size. Face the conduit exit
downward.
4. Assemble the corrugated tube connector (GV-Mount203, No. 4) with the self-prepared
corrugated tube.
A. Dismantle the supplied corrugated tube connector. You should have 4 parts.
A B C D
B. Slide part A and part B to the self-prepared corrugated tube.
A+B C D
C. Screw part C to the tube.
D. Thread the necessary wires and cables through the corrugated tube, plug the tube
to the box and secure with part D.
Ethernet
Or
Power