Installation Guide
Table Of Contents
- GV-Mount Accessories Installation Guide(MT-E-EN)
- GV-Mount Accessories Installation Guide
- Copyright
- Contents
- Installation Overview
- Required Accessories
- Note for Installing Camera Outdoor
- Note for Adjusting Focus and Zoom
- Note for Closing the Bullet Camera Cover
- Note for Supported Power BoxTypes
- 1. Introduction
- 2. Installing the Vandal Proof IP Dome
- 2.1 Assembling the Vandal Proof IP Dome with the dome housing
- 2.3 Straight Tube Mount
- 2.4 L-Shaped Wall Mount
- 2.5 Wall Box Mount
- 2.6 Wall Pendant Mount
- 2.7 Convex Corner Mount with Pendant Tube
- 2.8 Convex Corner Mount with Wall Bracket
- 2.9 Convex Corner Box Mount
- 2.10 Concave Corner Mount with Pendant Tube
- 2.11 Concave Corner Mount with Wall Bracket
- 2.12 Pole Mount with Pendant Tube
- 2.13 Pole Mount with Wall Bracket
- 2.14 Pole Box Mount
- 3. Installing the Fixed IP Dome
- 4. Installing the Fisheye Camera
- 5. Installing the GV-SD220/220-S IP Speed Dome
- 6. Installing the Bullet Camera
- 7. Installing the Arctic Box Camera
- 8. Installing the Mini Fixed Dome
- 9. Installing the Mini Fixed Rugged Dome
- GV-Mount Accessories Installation Guide
106
4.5 Tilting Wall Mount
Front View
Side View: Flat
Side View: Tilted
Required accessories:
GV-Mount904
1. Unscrew the inner housing cover using the supplied torx wrench.
2. Assemble the tilting rack (GV-Mount904, No. 3) with the back plate (GV-Mount904, No. 2)
and secure them together with 3 short screws (GV-Mount904, No. 5) from the back.
Front View
Back View