Installation Guide
Table Of Contents
- GV-Mount Accessories Installation Guide(MT-E-EN)
- GV-Mount Accessories Installation Guide
- Copyright
- Contents
- Installation Overview
- Required Accessories
- Note for Installing Camera Outdoor
- Note for Adjusting Focus and Zoom
- Note for Closing the Bullet Camera Cover
- Note for Supported Power BoxTypes
- 1. Introduction
- 2. Installing the Vandal Proof IP Dome
- 2.1 Assembling the Vandal Proof IP Dome with the dome housing
- 2.3 Straight Tube Mount
- 2.4 L-Shaped Wall Mount
- 2.5 Wall Box Mount
- 2.6 Wall Pendant Mount
- 2.7 Convex Corner Mount with Pendant Tube
- 2.8 Convex Corner Mount with Wall Bracket
- 2.9 Convex Corner Box Mount
- 2.10 Concave Corner Mount with Pendant Tube
- 2.11 Concave Corner Mount with Wall Bracket
- 2.12 Pole Mount with Pendant Tube
- 2.13 Pole Mount with Wall Bracket
- 2.14 Pole Box Mount
- 3. Installing the Fixed IP Dome
- 4. Installing the Fisheye Camera
- 5. Installing the GV-SD220/220-S IP Speed Dome
- 6. Installing the Bullet Camera
- 7. Installing the Arctic Box Camera
- 8. Installing the Mini Fixed Dome
- 9. Installing the Mini Fixed Rugged Dome
- GV-Mount Accessories Installation Guide
Installing the Fisheye Camera
101
4
5. Secure the junction box (GV-Mount100, No. 1) to the ceiling with 4 self-prepared screws.
6. Assemble the corrugated tube connector (GV-Mount100, No. 6) with the self-prepared
corrugated tube.
A. Dismantle the supplied corrugated tube connector. You should have 4 components.
A B C D
B. Slide part A and part B to the self-prepared corrugated tube.
A+B C D
C. Screw part C to the tube.
D. Thread the necessary wires and cables from the ceiling through the corrugated tube,
plug the tube to the box and secure with part D.
Ethernet
Power
7. Connect the network, power and other cables to the camera. See 1.7 Connecting the
Data Cable, GV-Fisheye IP Camera H.264 User’s Manual on the software CD.