User's Manual

Eyr GNSS RTK System User Manual
www.satlab.com.se 29
Figure 2-3-26 DAM File
2.4 Static survey
Static survey is a kind of positioning survey, which is mainly used to establish various control
networks.
2.4.1 Static settings
There are two ways to set up the device to work in the static mode:
1. Satsurv software – static interface – to set up the static or temporary static mode.
2. Web interface – work mode – to set up the static or temporary static mode.
Users can download the static data file to the computer, if necessary, and then use the static
post-processing software (HBC data processing software package) to process the data.
2.4.2 Static data collection steps
1. Set up the receiver on a control point with a tripod, making sure the tripod is strictly
centered and leveled. The benchmark must be installed.
2. Measure the slant height of the receiver three times in three directions, ensuring that the
difference of each measurement is less than 3mm, and then take the average value as the final
height. The slant height of the receiver is measured from the center of the measuring point to
the upper part of the top of the benchmark.
3. Record the point name, S/N, receiver height and beginning time.
4. Press the power button to power-on and set up the static collecting mode.
5. Turn off the receiver after the static data is collected and record the turn-off time.