Assembly Instructions

Step 4
Turn over the Chair.
Cover the Bolts(①) using Caps(④).
Step 5
Your Chair is ready for use.
This Chair can only be used on a flat and level surface.
Exert pressure floorwards, onto the Chair with both your hands.
This pressure will help the Legs and Seat reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly
secured.
When tightening the Bolts tighten sequentially.
Do not tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and excute the same above process.
Step 3
Page 4 OF 5