Installation Guide

Package Contents
1of2
A
Crossbar
x1
IntegratedLED10W
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
LightSource:
EstimatedAssemblyTime:
Preparation:
ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
Fixture Body
x1
D
STEP 2 - Install the Crossbar to the junction box
A. Attach the Crossbar (A) to the Outlet Box with tabs on the top and
bottom. Secure it with Outlet Box Screws (not included), tighten
until snug.
Figure 2
Installation Guide
Mounting Screw
x2
B
Glass Shade
x2
E
STEP 1 - Install Glass Shade
A. By using the Allen Wrench (C), loosen the set screw and do not
remove it from the coupling.
B. Unlock the coupling so that the bobeche can be moved up.
C. Place the glass holder inside of the Glass Shade (E).
D. Tighten the coupling to engage the Glass Shade (E) between the
bobeche and the glass holder.
E. Tighten the set screw on the coupling by using the Allen Wrench (C).
E
D
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Allen Wrench
x1
C
Tab
A
Supply Wires
with Ground Wire
Outlet Box Screws
(not included)
Outlet Box
Figure 1
C
Glass Holder
Set Screw
Coupling
Bobeche
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Figure 3
Pleasegoto our website forproductcleaningtips.Gotothe
Care + Maintenance
selection.