Assembly Instructions

Step 3
Place the Seat(A) on the side of a Table, perpendicular to the Table
Top.
Install the Leg(B) into the base of the Seat(A) by placing one
Gasket(①) onto the threaded stem.
Insert threaded stem of Leg(B) into one corner of the Seat(A) and
tighten by turning the Leg clockwise.
Repeat the same process to with the remaining three Legs(B).
Stand the Chair up, and place it on a LEVEL SURFACE to test for
wobbles.
If you find the Chair is uneven, identify the corresponding Leg and
"add or remove" a Gasket to achieve evenness.
Note: The use of Gaskets are OPTIONAL and are especially
useful to help alleviate slight wobbles. Some Legs may need
more than one whilst some Legs may not need any.
Finally put the Cushion(C) on the Seat(A) as shown above.
Test for Stability
Seat(A)
Cushion(C)
Leg(B)
Leg(B)
Page 5 OF 7