Installation & Assembly

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and

hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.

Estimated Assembly Time: 30 minutes.

1.Separate the Mounting Plate(A) from the Canopy(D)by removing the Canopy Nuts(E).

2.Insert the fixture wires through the Short Tube(J),Short Tube w/teeth(I),Long Tube(H),Hook(F) and Canopy(D).

Rotate each part clockwise till tight.

3.Hang the Hook(F) into the loop of the Canopy(D).

4.Attach the Mounting Plate (A) onto the J-box and secure it by turning the Mounting Screws (C)

clockwise till tight.

Connect, Hot, Black or Red Outlet Supply Wire to:

Connect, Neutral, White Outlet Supply Wire to:

Black

White

* Parallel Cord (round & smooth)

* Parallel Cord (square & ridged)

Clear, Brown, Gold or Black without Tracer (colored

stripes)

Clear, Brown, Gold or Black with Tracer (colored stripes)

Insulated Wire (not green) with copper metal conductor

Insulated Wire (not green) with Silver metal conductor.

*Note: When parallel wire ( SPT I & SPT II ) is used. The neutral wire is square shaped

and ridged and the hot wire will be round in shape and smooth. ( See Illustration on left. )

Grounding Instructions:

a) For installation in the United States: Wrap ground wire from outlet box around green

ground screw(F) on mounting bracket, no less than 2" from wire end. Tighten ground screw. If

fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector.

b) For installation in Canada: If fixture is supplied with ground wire, wrap ground wire

around green grounding screw on mounting bracket. Tighten ground screw.

5.Attach the Canopy(D) to the Mounting Plate (A) and fix it by turning the Canopy Nut (E) clockwise.

6 Insert the bulbs (L) into the Sockes. Be sure to use light bulb(L) with wattage no greater than

specified on this fixture. Make sure that electrical current is turned off before changing bulbs.

7.Place the Glass Shades(M) over the sockets and fix them in place by turning the

Glass Screws(G) clockwise till tight.

PLEASUE USE TYPE"B" BULB MAX 40-WATT OR CFL BULB MAX 13-WATT OR LED MAX 9-WATT OR EDISON

BULB MAX 40-WATT

THERE ARE 6 X 4W LED BULBS IN THE BOX.

ENJOY YOUR LAMP

2/2